Piranha Slot Motors 25k Ball Bearing S-Can Motor and Leads

Piranha High Performance Slot Motor featuring S-Can motor - rated at 25,000 RPM / 185 g*cm torque at 12VDC. Motor Shaft OD is 2.0MM.  Features include: Smooth, easy-to-drive powerband. Ball bearings support armature shaft. Dual armature shaft can be used with can or end-bell drive setup. These tiny motors for slot cars include tapped holes for securing to motor pod with screws (can end). Pre-soldered silicone lead wires. The Piranha 25K is a great motor for home, club or proxy racing and is an instant performance enhancement for Carrera, Scalextric, Fly, Ninco, NSR, Avant, and other brand 1:32 slot cars.

Note: For most cars, install the pinion gear from the original motor on to the Piranha motor and simply snap in place. However, for some cars, including Carrera 132, it is necessary to shorten the armature shaft on the end-bell side of the motor. Cut using a Dremel tool with a cut off wheel. Leave approximately 1/8" of motor shaft. Tape over the holes on these motors while cutting.

*The label affixed to this motor appears to read 15,000 RPM instead of 25,000 RPM, but is in fact rated 25,000 RPM.


Add to Cart:
  • Model: PSM2
  • Manufactured by: Piranha

Ask a Question

Manufacturer Info

Your IP Address is:
Copyright © 2024 LEB Hobbies, LLC - Built by PRO-Webs.net